|
|
|
Extended Multiple Keyer Operation
Keyer (and Transform) delegation should be more consistent. Only some features operate when multiple delegations are enabled.
- Currently it is possible to delegate the keyer subpanel to more than one keyer simultaneously by pressing the "Key n" button at the far right of the Keyer Source Select row for each keyer you want to operate. This allows simultaneous selection of Keyer modes, Clip/Gain controls, matte fills etc.
- It should also be possible to select the Mattes sub-panel's "Key Only" sub-delegation options of "PstPtn Border", "Border Line" and "Matte Fill" to simultaneously adjust mattes for multiple keyers. This does not operate. (The manual says it does.)
- If multiple Keyers are delegated on the main panel, entering the "Keyers" Menu should have those same keyers delegated to allow simultaneous entry of numbers via keypad or operation of other controls. (This would be an extension of the concept as used in Button Mapping - enable multiple units then set them all.)
- If multiple Transform Engines are delegated on the main panel, entering the "Transform" Menu should have those same TEs delegated to allow simultaneous entry of numbers via keypad or operation of other controls. In this way, you could add the same values of Crop Softness (for example) to all delegated TEs.
If you have a tip that you think would suit this category, please email me using the Contact link above.
|
|